Mendig New York Oklahoma Trip2 (V5.0)
Flight created on 12.02.2020 (Changed 10.02.2025 to V5.0, Mooney Bravo installed and weather optimized).
This mission
only works with P3dV5 and P3dV6.
For P3dV4
download the appropriate version here:
https://www.andi20.ch/p3d
Estimated flight duration with AN2 6h (48h all 8 trips)
The An2 flies at 100, the Mooney at 160 KIAS, so all times are shorter by a factor of 1.6.
Level of difficulty easy - difficult (with - without help)
Task: Fly from Mendig (Germany) to Oklahoma (USA).
Introduction
This is the re-enacted flight of Steel Buddy Michael, from Mendig to New York and on to Oklahoma, with the old An2 biplane.
Because the AN2 is not P3dV5/6-compatible, here is the alternative version with the Mooney.
If you still own a P3dV4 and have purchased the AN2, you can download an AN2-compatible version at this address:
https://www.andi20.ch/p3d
So that some AN2 feeling remains, I'm leaving the help texts and pictures for the AN2.
Adjustments and new features in this version:
1) Pumping fuel:
- The Mooney Acclaim flies the same distance with 18% fuel as the An2 with 90%.
So that you can still enjoy the pump fuel, the Mooney Acclaim starts with 28% fuel.
- The Mooney Bravo consumes 70% fuel for the same distance as the AN2 with 90%.
2) Because the Mooney Acclaim is not simulated very realistically, I have added the Mooney Bravo as an alternative aircraft.
- With the Acclaim, the mixture setting has no influence on the engine performance, regardless of the altitude, the mixture can be set anywhere between 6 and 100%.
- The fuel consumption is far too low: fully loaded and with 100% fuel, the Acclaim easily flies from Paris to New York (3150nm) and still has more than 4% fuel in the tank, which is enough for another 150nm. According to the data sheet, only 1400nm are possible.
3) AN2 had neither autopilot nor GPS:
The Mooney has both. The use of both makes the flight easier, but can lead to problems if, for example, GPS steers somewhere other than the air traffic control specifies.
4) Overheating problems and other things that only occur with AN2:
There are no overheating problems etc.
- For the Mooney Bravo I have artificially built in an overheating problem:
If you fly for a long time at 100% power, and/or at 100% propeller speed and the cooling air flaps are closed, an oil leak occurs. In this case, you have up to 50 minutes to make an emergency landing somewhere, repair the engine and continue flying.
- The flight with the Mooney Acclaim is unchanged, there is no problem.
5) Now you can fly the flight with the Mooney Bravo a little more realistically.
Ignore the information on power, speed and flap position, they only apply to the AN2.
- Fly at maximum speed, approx. 165 knots and adjust the mixture of the Mooney Bravo according to the altitude.
- Remember to open the cooling air flaps on the Mooney Bravo when setting full power and/or propeller speed.
General information
Michael has installed additional tanks in the Antonov, this additional fuel must be filled into the fuel tanks by hand if required.
I have modified the AN2 a little for this flight, i.e. adapted the switch for the cab light so that this switch now triggers refueling.
It is best to refuel several reserve tanks if the fuel is below 10%.
Here are the most important instruments of the An2 incl. cab light:
The cab light of the Mooney is overhead:
Acclaimc Bravo
Info about Mooney Bravo
Overview:
The mixture must be set correctly when climbing. The FuelFlow display helps you to do this. The higher the FuelFlow value, the more optimal the mixture setting.
During take-off and climb, the aircraft is normally flown at maximum power and propeller speed.
Power 100% Propeller 100%
For cruise flight, reduce the propeller speed to the green range and reduce the power.
Power 90% Propeller 90%
To prevent the engine from overheating, open the cooling air flaps.
The fuel gauge on the Mooney Bravo is based on the same panic principle as in a car:
If the needle points to the red area, it suggests a lack of fuel, although you still have plenty of fuel in the tank.
Here is the fuel level, with the corresponding display:
30% 20%
15% 10%
When the needle is at the left stop, there is still 10% in the tank.
It is therefore sufficient to refuel as soon as the needle touches the E.
Info about Trip 2
Trip 2 goes from Scotland to Iceland.
This flight takes about 5h over water.
You start in good weather, in Iceland the weather is very changeable.
Start of the flight
Trip 2: Wick (EGPC) - Reykjavik (BIRK) 638nm
After a short night, this flight takes off early in the morning (9h local time, 8h GTM). The weather is good.
You are at Wick on runway 31. Take off, climb to 4000 feet and fly heading 310.
Shortly after takeoff you leave Scotland. From now on you will see only water for about 5 hours. Trim the airplane well before you go to 16x or 32x speed.
After about 3.5h you fly towards a weather front.
Suddenly you have zero visibility.
Top: Flusi view Bottom: Original Steel Buddies view
You see, I am close to the original flight....
You will have to fly under the clouds.
Now you will fly 150nm at an altitude of 150m (500feet).
After a long low flight, the coastline of Iceland finally appears. By the way, this is a good time to refill some fuel.
I recommend not to use flight acceleration from here on, because you will have a lot to do until you reach the destination airport.
Climb a little bit as soon as you fly over land, but better don't lose visibility to the ground.
I recommend a distance to the ground of about 100-150m (300-500feet).
The ground radar of the An2 is very helpful:
Attention: There will be mountains in the fog.
Then climb immediately to about 1700m (5500feet).
You are now stuck at altitude in the fog and will need help from air traffic control.
Don't worry, you will be guided fine to the airport....
As the airfield approaches prepare for landing (runway 31).
The tower will guide you to the gas station.
The red line shows a possible taxiway.
Note: If you want to do this flight in nice weather to see the beautiful area of Iceland, change the weather settings to nice weather, (or just delete the "ME-NY2.wx" file).
I hope you enjoyed this flight, if so please give feedback to p3d@andi20.ch . Also send error messages (spelling mistakes, wrong information, etc.) to p3d@andi20.ch, I appreciate any feedback.